Western Reserve Controls 1782-JDC Manual de usuario descargar pdf (Pagina 30)

Western Reserve Controls 1782-JDM User’s Manual

PUB 24.0

Problem: JDM operates on DeviceNet but does not seem to handle ModBus activity.

Possible Solutions:

1. Check the RX and TX LEDs on the JDM. A successful transmission will appear as:

• Brief TX LED flash

• Brief RX LED flash

• Both LEDs off

If the sequence does not appear as this, then there is a wiring problem.

2. If this is an RS485 link, make sure it is properly terminated. (121ohm resistor at each

end.)

3. Make sure the TX and RX, or SIG+ and SIG-, are not crossed.

4. Make sure your signal commons are connected.

1 2 ... 25 26 27 28 29 30 31 32 33 34

Sin comentarios

Western Reserve Controls 1782-JDC Manual de usuario Pagina 30